My buddy has a vinyl cutter that is a USCutter SC Plotter. Im not sure what size and everything, but its pretty small. The computer we are using with it is a 64-bit HP netbook that is running windows 7. We installed SCAL 3 last night and that works fine on the computer, but when we try to connect the cutter via usb, the computer won't read it and says it failed to connect. We have tried downloading a bunch of different drivers that are supposedly for windows 7, but none of them seem to work. What could be the problem. Sorry if any of this is too unclear, we are both newbies at this and need a little help! • You have to save the installation file of HP LaserJet 1000 driver. Laserjet 1000 windows 10 driver. I have recently purchased a UScutter SC 801 - 34' vinyl cutter. My intent is to use it with my Linux Mint 17.1 (cinnamon) - i7, using Inkscape. Here is where I am at: I am starting from scratch: 1. New installation of Inkscape – I went to the newest version 0.92.1 2. ![]() Official USCutter MH-1351 Free Driver Download - mh-cutter_driver__mk_.zip (1825108). World's most popular driver download site. Official USCutter MH-1351 Free Driver Download - mh-cutter_driver__mk_.zip (1825108). World's most popular driver download site. My Vinyl cutter is a UScutter – model SC 801 – a 34″ wide cutter – newly purchased 3. I am using Linux Mint 17.1, cinnamon, on an i7 processor 4. No 9 pin serial port on this machine, only USB – wanting to use USB. I am not sure – but I think the first step is to ensure that my UScutter is recognized. I did the following below: ~ $ dmesg| grep tty [ 0.000000] console [tty0] enabled [ 0.912127] 00:0b: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A [ 8.291735] usb 3-4: FTDI USB Serial Device converter now attached to ttyUSB0 I think this means the device is attached, but I do not know how to assure this or make sure it will survive a reboot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |